Easy Nerf Maverick Mod

How to Easily Mod the Nerf Maverick

Materials

• Four five cent coins [AUS Currency
• Philips Head screw driver
• Nerf Maverick
• Something can hold screws 
• These Instructions

Step 1

Get Nerf Maverick, screwdriver, five cent coins and put them in the "something that can hold screws" bring this as well and have them all handy. [with the instructions]

Step 2

Unscrew [with the screw driver] the Nerf Maverick. [Be careful there are two under the cocking mechanism] Than put the screws in "something that can hold screws".

Step 3

Carfeully pull out the spring and air compressor without getting out anything else.

Step 4

Put four, five cent peices behind where the spring goes.

Step 5

Place spring and air compressor back. [Be carful as there are a few mechanisms like the one below the air compressor where you have to put back.

This is the sliding mechanism

Step 6

See the spring above the the spring and air compressor? Well find the little metal stick on one of the things that slide when you are cocking it. You need to put the metal stick in the sliding  mechanism that fits the half that you are working on. Than put the sliding mechanism with the peice of metal on the right half that it goes on. You need to make sure that the small metal cylinder fits through the circular gap of the spring. [right on the edge]

Step 7

Screw the Maverick back together not forgetting to do the two inside the sliding mechanism. And then You are done!!

You May Be Wondering How It Works

It works by making more pressure on the spring so that it pushes the air compressor harder and faster therefore creating more wind so it goes a few metres further.

If you have any problemos please tell I am happy to help you out.

BTW if you do not own five cent coins or you don't want to waste 20 cents use cardboard or something like that.

THANKYOU VERY MUCH!!!